Advertisement
O P E R AT I O N
This appliance is for household
use only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or be
pulled by the cord.
2. Plug the fan into a 230-volt AC
electrical outlet (ordinary
household current). DO NOT use
any other type of outlet. Make
sure that the rated voltage of the
fan is the same as the power
source before plugging it into
the power source.
3. Turn the fan "ON" or "OFF" by
sliding the Power/Speed Control
to the right or left. The power
should always be OFF before
unplugging the fan.
4. To select the speed, move the
Power/Speed Control from OFF
to the desired speed setting:
O (off), I (low), II (medium),
III (High).
41631-01 05/06/2003
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten the
screw.
6. To make the fan oscillate, push
the oscillation knob down. To
stop oscillating, pull the oscilla-
tion knob up. The oscillation
knob is located on the top of the
fan housing, near the handle.
Handle
Power/Speed
Control Switch
FIGURE 3
Oscillation
Knob
Motor
Housing
Up/Down
Adjustment
Screw
Base
5
Advertisement
