Sub-Zero 427G Installation Manual page 38

Model WS-30 Installation
Anti-Tip Bracket Installation
WOOD FLOOR APPLICATIONS
After properly locating the anti-tip brackets in the rough
opening, drill pilot holes
wall studs and/or wall plate. Use the #12 x 2
HD zinc screws and #12 flat washers to secure the
brackets in place. Make sure the screws penetrate
through the flooring material and into wall studs or wall
3
plate a minimum of / "
4
CONCRETE FLOOR APPLICATIONS
After properly locating the anti-tip brackets in the rough
opening, drill pilot holes
wall studs and/or wall plate. Then drill
holes into the concrete a minimum of 1
1
Use the #12 x 2 / " PH pan HD zinc screws and #12 flat
2
washers to secure the brackets to the wall and use the
3 3
/ "–16 x 3 / " wedge anchors to secure the brackets to
8 4
the floor. Make sure the screws penetrate the wall studs or
wall plate a minimum of
below.
24"
(610)
4"
(102)
MIN
FINISHED
FLOORING
WALL PLATE
SUBFLOORING
WOOD FLOOR
Wood floor.
3
/ " diameter maximum in the
(5)
16
1
/ " PH pan
2
. Refer to the illustration below.
(19)
3
/ " diameter maximum in the
(5)
16
3
/ " diameter
(10)
8
1
/ " deep.
(38)
2
3
/ " . Refer to the illustration
(19)
4
FINISHED FINISHED
FLOORING FLOORING
WALL PLATE WALL PLATE
SUBFLOORING SUBFLOORING
1 1
CONCRETE CONCRETE
FLOOR
FLOOR
Concrete floor.
INSTALL CONCRETE WEDGE ANCHORS:
1) Drill a
minimum embedment. Clean the hole or continue
drilling additional depth to accommodate drill fines.
Use a carbide drill bit manufactured within ANSI
B94.12-77.
2) Assemble the washer and nut flush with the end of
anchor to protect threads. Drive the anchor through the
material to be fastened until the washer is flush with
the surface material.
3) Expand the anchor by tightening the nut 3–5 turns past
hand-tight position or to 25 foot-pounds of torque.
Always wear safety glasses and use other necessary
protective devices or apparel when installing or
working with anchors.
Anchors are not recommended for use in lightweight
masonry material such as block or brick, or for use in
new concrete which has not had sufficient time to cure.
The use of core drills is not recommended to drill holes
for the anchors.
24"
(610)
4"
(102)
MIN
1 1 / / " "
2 (38)
2 (38)
min MIN
3
/ " diameter hole any depth exceeding the
(10)
8
38