Setting Up The Monitor; Installing The Monitor Pedestal Base - HP LP2480ZX User Manual

3

Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the off position.
The master power switch turns off all power to the monitor.
CAUTION:
around all sides and the cooling fan below the handle must not be blocked.

Installing the Monitor Pedestal Base

NOTE: Do not install the pedestal base if the monitor will be used on a wall, swing arm, or other
mounting fixture; instead see
1. Using both hands, position the monitor over the pedestal base.
CAUTION:
uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover
to its normal condition.
2. Press down firmly on the monitor to lock the pedestal base in place. When the base locks, it will
make a clicking sound.
Figure 3-1
For proper ventilation, the monitor must have a minimum of 5 cm (2 inches) of clearance
Mounting the Monitor on page 16
Do not touch the surface of the LCD panel. Pressure on the panel may cause non-
Inserting the Monitor into the Pedestal Base
in this chapter.
Installing the Monitor Pedestal Base 7