Installation Summary - Cisco Aironet 1300 Series Hardware Installation Manual

Chapter 2 Installation Overview
Figure 2-4
1
2
Figure 2-5
1

Installation Summary

You should read and carefully follow the installation instructions before connecing the system to its
Caution
power source. The access point/bridge and power injector can be damaged by incorrect power
application.
To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna
Note
must be professionally installed. The network administrator or other IT professional responsible for
installing and configuring the unit is a suitable professional installer. Following installation, access to the
unit should be password protected by the network administrator to maintain regulatory compliance.
During the installation of the access point/bridge, you will perform the following operations:
•
OL-5048-02
Power Module
1
48-VDC power output cable
Power module
Grounding Block
1 1 2
F-type coaxial connectors
Connect a user-supplied Category 5 Ethernet cable from your wired LAN network to the power
injector.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
3
2
3
AC power cord
2 Ground wire lug

Installation Summary

2-9