Cisco Aironet 1300 Series Hardware Installation Manual page 84

Checking the LEDs
The LED blinking error codes are described in
Table 7-2
LED
Ethernet
Radio
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
7-4
LED Blinking Error Codes
Blinking Codes
First Second
Digit Digit Description
2 1 Ethernet cable problem—verify that the cable is properly connected
and not defective. This error might also indicate a problem with the
Ethernet link. If the cable is connected properly and not defective,
contact technical support for assistance.
1 2 Radio not detected—contact technical support for assistance.
1 3 Radio not ready—contact technical support for assistance.
1 4 Radio did not start—contact technical support for assistance.
1 5 Radio failure—contact technical support for assistance.
1 6 Radio did not flash its firmware—contact technical support for
assistance.
Table 7-2.
Chapter 7 Troubleshooting
OL-5048-02