Declaration Of Conformity For Rf Exposure; Guidelines For Operating Cisco Aironet Access Points And Bridges In Japan; Japanese Translation; English Translation - Cisco Aironet 1300 Series Hardware Installation Manual

Appendix B Declarations of Conformity and Regulatory Information

Declaration of Conformity for RF Exposure

The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements in CFR 47 Sections 2.1091, and 15.247 (b) (4) addressing RF Exposure from radio
frequency devices. The AIR-ANT3338 dish antenna should be installed more than 22 cm from your body
or nearby persons. All other antennas should be installed more than 20 cm from your body or nearby
persons.
Guidelines for Operating Cisco Aironet Access Points and
Bridges in Japan
This section provides guidelines for avoiding interference when operating Cisco Aironet access points
and bridges in Japan. These guidelines are provided in both Japanese and English.

Japanese Translation

English Translation

This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices
such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio
stations and unlicensed specified low-power radio stations) used in factory production lines.
1.
2.
OL-5048-02
03-5549-6500
Before using this equipment, make sure that no premises radio stations or specified low-power radio
stations of RF-ID are used in the vicinity.
If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the
frequency or stop using the device; contact the number below and ask for recommendations on
avoiding radio interference, such as setting partitions.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
Declaration of Conformity for RF Exposure
B-5