Route Switch Processor 720
Table 2-1
Product Number
WS-X6K-S2-MSFC2
WS-X6K-S2U-MSFC2
WS-X6K-S2-PFC2
WS-X6500-SFM2
Note
Route Switch Processor 720
This section describes the Route Switch Processor 720 (RSP720). The Cisco 7600 RSP720 consists of a
full-size board and two integrated daughter cards: the MSFC4 and a PFC3C or PFC3CXL. The RSP720
has an integrated switch fabric that interconnects all of the line cards in the Cisco 7600 router with
point-to-point 20-Gbps full-duplex serial channels.
Note
•
•
Figure 2-1
panel. See
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-6
Route Switch Processor and Supervisor Engine Configurations (continued)
The Sup2 is not supported in Cisco IOS Release 12.2SRA and later releases.
Cisco IOS Release 12.2SRB and later releases support the RSP720; earlier releases do not.
The RSP720 is supported on all Cisco 7600 routers (including enhanced chassis) except the Cisco
7603 and the Cisco OSR-7609.
Cisco IOS Release 12.2SRC and later releases support an RSP720 that has 10GE uplinks
(RSP720-3C-10GE and RSP720-3CXL-10GE). See the
on page 2-8
for more information.
shows the RSP720-3C-GE front panel, which is the same as the RSP720-3CXL-GE front
Table 2-2
and
Table 2-3
Chapter 2
Description
Two dual-port 1000BASE-X GBIC uplinks, 16-MB bootflash,
•
128-MB DRAM on supervisor engine and 128 MB on MSFC2
PFC2 and MSFC2
•
Fabric enabled to support optional switch fabric module (SFM2)
•
QoS port architecture (Rx/Tx): 1p1q4t/1p2q2t
•
Two dual-port 1000BASE-X GBIC uplinks, 32-MB bootflash,
•
256-MB DRAM on supervisor engine and 256 MB on MSFC2
PFC2 and MSFC2
•
Fabric enabled to support optional SFM2
•
QoS port architecture (Rx/Tx): 1p1q4t/1p2q2t
•
•
Two dual-port 1000BASE-X GBIC uplinks
PFC2; fabric enabled, supports optional SFM2
•
•
QoS port architecture (Rx/Tx): 1p1q4t/1p2q2t
(Optional) SFM2
•
"RSP720 with 10GE Uplink Ports" section
for information about the front-panel controls and LEDs.
Route Switch Processors and Supervisor Engines
OL-10100-04