Verifying Interface Settings And Port Operation - Cisco Catalyst 3750G Getting Started Manual

Verifying Interface Settings and Port Operation

Follow these steps to verify that your interface configurations have been set properly and that the
controller ports are operational.
Enter show interface summary, and press Enter. This display shows the controller interface
Step 1
configurations:
Interface Name
------------------------------ ----
ap-manager
management
service-port
virtual
Link aggregation (LAG) is always enabled for the integrated wireless LAN controller and
cannot be disabled. LAG bundles all of the controller distribution system ports into a
single IEEE 802.3ad port channel. See the Cisco Wireless LAN Controller Configuration
Guide 4.0 or later for more information.
Enter show port summary, and press Enter. This display shows the status of the controller
Step 2
distribution system ports, which serve as the data path between the controller and the
Cisco lightweight access points and to which the controller management and AP-manager
interfaces are mapped.
Pr Type
-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------
1 Normal
2 Normal
A link status of Up means that the controller ports are fully operational.
STP Admin Physical
Stat Mode Mode
Forw Enable Auto
Forw Enable Auto
Port Vlan Id IP Address
-------- --------------
LAG 10
LAG 10
N/A N/A
N/A N/A
Physical Link
Status Status
1000 Full Up
1000 Full Up
Type
-------
10.91.104.99 Static
10.91.104.93 Static
10.10.0.9 Static
1.1.1.1 Static
Link Mcast
Trap Appliance
Enable Enable
Enable Enable
Ap Mgr
-----
Yes
No
No
No
POE
N/A
N/A
21