Cisco Catalyst 3750G Getting Started Manual page 13

In the System Name field, enter the system name, which is the name that you want to
Step 7
assign to the controller. You can enter up to 32 ASCII characters.
In the User Name and Password fields, enter the administrative username and password
Step 8
for this controller. You can enter up to 24 ASCII characters for each. The default
administrative username and password are both admin.
Click Next. The Service Interface Configuration page appears.
Step 9
If you want the controller service-port interface to get an IP address from a DHCP server,
Step 10
check the DHCP Protocol Enabled check box. If you do not want to use the service port
or if you want to assign a static IP address to the service-port interface, leave the check
box unchecked.
The service-port interface controls communications through the service port, which is
reserved for out-of-band management of the controller and for system recovery and
maintenance in the event of a network failure. Its IP address must be on a different subnet
from the management and AP-manager interfaces. You can use this configuration to
manage the controller directly or through a dedicated management network to ensure
service access during network downtime.
If you did not check the DHCP Protocol Enabled check box in Step 10, leave the IP
Step 11
address and the netmask for the service-port interface as they are, or change them as
necessary. If you do not want to use the service port, enter 0.0.0.0 for both the IP address
and the netmask.
13