Environmental And System Requirements - Cisco WS-X6066-SLB-APC Installation Note

Environmental and System Requirements

This section describes the environmental and system requirements.
•
•
•
•
•
•
Environmental Requirements
Table 2
Table 2
Item
Temperature, ambient operating
Temperature, ambient nonoperating
Humidity (RH), ambient (noncondensing)
operating
Nonoperating relative humidity (noncondensing) 5% to 95%
System Requirements
Before you install the CSM in the Catalyst 6500 series switch, make sure that the switch meets the
hardware and software requirements listed in this section.
You can use the Multilayer Switch Feature Card (MSFC), which is internal to the Catalyst 6500 series
Caution
switch, to route traffic on either the client side or the server side of the CSM, but not both simultaneously
(unless policy-based routing is used).
Memory Requirements
The CSM memory is not configurable.
CSM software release 4.1(2) requires Cisco IOS software Release 12.1(8a)EX or higher. However, the
features new to CSM release 4.1(2) are available only with Cisco IOS Software Release 12.1(19) E and
Catalyst operating system software release 7.6 and higher.
78-15751-03
Environmental Requirements, page 9
System Requirements, page 9
Memory Requirements, page 9
Power Supply, page 10
Hardware Supported, page 10
Software Compatibility, page 10
lists the environmental requirements for the CSM.
CSM Environmental Requirements
Specification
o
0 to 40
o
–40 to 70
10% to 90%
Catalyst 6500 Series Switch Content Switching Module Installation Note
Environmental and System Requirements
o o o
C (32 to 104 F)
o o o
C (–40 to 158 F)
9