Cisco WS-X6066-SLB-APC Installation Note page 18

Installing the CSM
Figure 5
FAN
STATUS
o
Carefully slide the supervisor engine or module into the slot until the EMI gasket along the right
b.
edge of the module makes contact with the module in the slot adjacent to it and both ejector levers
have closed to approximately 45 degrees with respect to the module faceplate. (See
Using the thumb and forefinger of each hand, grasp the two ejector levers and exert a slight pressure
c.
to the left, deflecting the module approximately 0.040 inches (1 mm) to create a small gap between
the modules EMI gasket and the module adjacent to it. (See
Catalyst 6500 Series Switch Content Switching Module Installation Note
18
Positioning the Module in a Vertical Slot Chassis
o
INPUT
FAN OUTPUT
OK
OK FAIL
INPUT
FAN OUTPUT
OK
OK FAIL
Insert module
between slot guides
Ejector lever fully
extended
EMI
gasket
EMI
gasket
Figure
Figure 6.)
6.)
78-15751-03