Check & Change Page In The Light Mode; Controlling All Together; Setting All Together - Sanyo PLV-80 Series Owner's Manual

Chapter 4 Controlling the Projector
Connection status
Blinking: Connected
Gray: Disconnected
(Check&Change page in the light mode)

Controlling all together

"Power & Status", "PC adjustment", "Control" and "Setting"
can be controlled all together. Set "ON" the multi control
setting and adjust controls of each menu. The setting
value is applied to the registered projectors sequentially .
This is effective only if the mode of the registered projector is
✐
set to "Control".

Setting all together

"E-mail setting", "SNMP setting" and "Timer" can be set all
together. Set "ON" the multi control setting and items of
each menu. The setting value is applied to the registered
projectors sequentially.
This is effective only if the mode of the registered projector is
✐
set to "Control".

Check & Change page in the light mode
Following functions in the "Check&Change" page are
not available in the light mode.
- Changing the control mode.
- Deleting the registered IP address
- Indicating the each status
- Indicating the each memo
This indicates that the
mode is "Control".