Image Adjustment - Sanyo PLV-80 Series Owner's Manual

Chapter 4 Controlling the Projector

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.
Input source
Image mode Video Computer
Standard(AV)
Cinema
Standard(PC)
Real
Image1 - 10

Item
Contrast .................Adjusts picture contrast (0~ 63)
Brightness ............Adjusts picture brightness (0~ 63)
Color .........................Adjusts picture color saturation (0~ 63)
Tint ............................Adjusts picture hue (0~ 63)
Item
Color Temp. ......... Sets a color temperature mode. (X Low, Low, Mid, High,
White Balance
Red, Green,
Blue ..................... Adjusts each white balance respectively. (0~ 63)
Sharpness .............Adjusts picture sharpness. (0~ 31)
* When changing the value of the white balance, the color temp.
indicates "Adj."
Item
Gamma ...................... Adjusts brightness of darker part of the picture. (0~
Noise reduction .. Switches noise reduction mode (OFF, L1, L2)
Progressive ........... Switches progressive mode (ON, OFF, Film)
Reset.........................Resets the Image adjustment to previous levels.
Store ......................... Stores the Image adjust-
Load .......................... Loads the Image mode.
*
4
*
4
*
4
✐ The mark "
*
4
selected input source. The error message appears when
4 4
selecting the disabled image mode indicated with "*".
Description
Description
Adj.)
Description
15)
ment values. Select an
item [Image1 - Image10]
from the pull-down menu
and click Store button.
Select an image mode
from the pull-down
menu and click Load
button. There may not be
available mode depend-
ing on the input mode as
shown in the table left.
" means that the available image mode in the
4