Connecting A Tv, Vcr, Dvd And A/V Receiver Or Amplifier - Motorola DCT2000 Installation Manual

Connecting a TV, VCR, DVD and A / V
Receiver or Amplifier
1
Connect an RF coaxial cable between the cable wall outlet and the CABLE
IN connector on the DCT2000.
2
Connect the RF coaxial cable, supplied with the DCT2000, between the
RF IN and TO RF IN connectors on the DCT2000.
3
Connect a stereo audio cable between the AUDIO OUT R and L
connectors on the DCT2000 and the CABLE / TV AUDIO R and L
connectors on the A / V receiver or amplifier.
4
Connect a video cable between the VIDEO connector on the DCT2000
and the CABLE / TV VIDEO VIDEO connector on the A / V receiver or
amplifier.
5
Connect a stereo audio cable between the DVD AUDIO R and L
connectors on the A / V receiver or amplifier and the AUDIO OUT
ANALOG R and L connectors on the DVD.
6
Connect a video cable between the DVD VIDEO connector on the A / V
receiver or amplifier and the VIDEO OUT VIDEO connector on the DVD.
7
Connect a stereo audio cable between the VCR IN AUDIO R and L
connectors on the A / V receiver or amplifier and the OUTPUT AUDIO R
and L connectors on the VCR.
8
Connect a video cable between the VCR IN VIDEO VIDEO connector on
the A / V receiver or amplifier and the OUTPUT VIDEO connector on the
VCR.
9
Connect a stereo audio cable between the VCR OUT AUDIO R and L
connectors on the A / V receiver or amplifier and the INPUT AUDIO R and
L connectors on the VCR.
10
Connect a video cable between the VCR OUT VIDEO VIDEO connector
on the A / V receiver or amplifier and the INPUT VIDEO connector on the
VCR.
11
Connect a video cable between the TV / MONITOR OUTPUT connector on
the A / V receiver or amplifier and the INPUT VIDEO connector on the TV.
Cable connections marked with an * are optional. These connections allow the
use of the DCT2000 and TV without powering-on the VCR and A/V Receiver.
The optional connections are:
•
Connect a RF coaxial cable between the TO TV / VCR connector on the
DCT2000 and the CABLE / ANTENNA IN connector on the VCR.
•
Connect a RF coaxial cable between the To TV connector on the VCR and
the CABLE / ANTENNA IN connector on the TV.
This cable configuration may be used for a mono or stereo TV, because
the TV audio and video jacks are not used.
When using a mono VCR with this setup, a stereo audio cable with a Y- cable
adapter is needed to connect the mono VCR to the A / V receiver or amplifier.
3 7