Pride Mobility Jazzy 1113 Owner's Manual page 28

1. Place the three frame assemblies next to each other as shown in figure 18.
2. Stand behind the assemblies, grasp the front frame with your left hand, and fit the notch on the
bottom bar of the front frame onto the locating pin on the lower section of the right frame
assembly. (The frame is shown in figure 19.)
3. Pivot the front frame top bar toward the right frame assembly and, while holding the latch release lever, push
the top bar of the front frame onto the locking mechanism until the two assemblies snap securely into place.
Release the latch release lever to hold the two assemblies together.
NOTE: The front frame should be positioned with the two semicircular notches in the vertical bar facing
forward.
4. Grasp the other frame assembly and lift the frame assembly into an upright position.
5. Tilt the front frame and the attached frame assembly (right side) so that the notch on the bottom bar of the front
frame fits onto the locating pin on the bottom section of the other frame assembly (left side). You will also have
to tilt the frame assembly (left side) slightly away from the front frame to make the parts fit together. See figure 20.
6. Pivot together the right frame assembly and the front frame, while holding the latch release lever, until the
locking mechanism on the top bar of the front frame snaps securely to the left frame assembly. Release the
latch release lever to hold the two assemblies together.
WARNING ! Make certain that the front frame is snapped securely to both the right frame assembly
and to the left frame assembly.
Figure 18. Frame Assemblies
28
V I I . A S S E M B L Y
www.pridemobility.com
Figure 19. Front Frame Assembly
US Jazzy 1113/Rev I/Feb03