Table of Contents
Advertisement
Attention:
To avoid damaging the drive, follow these precautions:
v Use only the M3 mounting screws that are provided. If different screws must be
v Make sure that the chassis is not distorted. (Alignment to the horizontal or
v Make sure that no objects (screw heads, cables, or adjacent devices) are pressing
v Do not use a combination of the two sets of mounting holes.
v Do not obstruct the ventilation slots (top and rear) in the drive.
Attaching the cables
Locate the internal power cable in the server and connect it to the power connector
on the drive (see Figure 2-3).
Using the provided SCSI cable, attach the non-terminated end to the SCSI adapter
in the server and the terminated end to the back of the tape drive (see Figure 2-3).
Attention: To avoid problems with the tape drive, follow these precautions:
v
v Do not attach this tape drive to a SCSI RAID adapter.
Figure 2-3. Installing the SCSI cable
Completing the installation and turning on the tape drive
Before completing the installation, check your work to make sure that the power
and SCSI connectors are securely attached and that the cables are properly routed.
Then, turn on the server.
used, the length must be 5mm or less.
vertical plane should not exceed ±10°.)
against the frame.
Be sure to connect pin 1 on the cable to pin 1 on the drive. Pin 1 is the
rightmost pin in the top row of the connector pins.
SCSI connector
Power connector
Chapter 2. Installing the tape drive
2-3
Advertisement
Table of Contents
