Tools And Supplies Needed; Typical Fireplace Components; Inspect Fireplace And Components - Heatilator BIR42-B Owner's Manual

F. Tools and Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Level
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
G. Typical Fireplace Components
• Hearth Molded brick panel
- Molded brick panel kit must be installed, but is sold
separately
• Grate Assembly
• Transition Assembly (14-11 in.)
- Must be installed immediately on top of the fireplace
• Outside Air Kits
- Duct must be installed, but sold separately
Framing material
Non-combustible sealant
Gloves
Framing square
Electric drill and bits
Safety glasses
Tape measure
Heatilator • Birmingham BIR42-B • 4059-681• 11/11
H. Inspect Fireplace and Components
WARNING! Risk of Fire and/or Explosion! Damaged
parts could impair safe operation. DO NOT install dam-
aged, incomplete or substitute components. Keep fireplace
dry.
• Remove fireplace from pallet.
• Remove fireplace and components from packaging and
inspect for damage.
• Remove the transition, hearth molded brick panel, screens
and grate from inside the unit.
• Vent system components, doors, remaining molded brick
panels and mortar are shipped in separate packages.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
17