Speaker Connections - Profile California Mosfet 100SX Installation Instructions & Owner's Manual

The California amplifiers are capable of being bridged in a mono configuration. This feature
allows you the flexibility of using the amplifier to drive a ** subwoofer or a center channel. In
this configuration the amplifier sums the right and left channel to deliver one channel (mono)
output.
Please note: in order for the amplifier to sum right and left signal information, both right and
left RCA connections must be made.
**CAUTION! In the bridged mode, the amplifier must see a 4 Ohm load or higher. Any
lower than 4 Ohms will cause the amplifier to overheat and possibly cause permanent
damage to the amplifier!
TWO CHANNEL BRIDGED SPEAKER CONNECTIONS
FOUR CHANNEL BRIDGED SPEAKER CONNECTIONS
S
PEAKER CONNECTIONS (BRIDGED)
FUSE
4 Ohm Speaker 4 Ohm Speaker
CH1, 2
L + L - R + R -
BRIDGED
- -
+ +
4 Ohm Speaker 4 Ohm Speaker
B + REM GND L + L -
BRIDGED
+ +
CH3, 4
FUSE
L + L - R + R -
BRIDGED
- -
+ +
4 Ohm Speaker 4 Ohm Speaker
10
R + R -
- -
B + REM GND