Mounting Location - Profile California Mosfet 100SX Installation Instructions & Owner's Manual

Before you start the installation, it will be necessary to find a mounting location for the
amplifier. Find a location in which the amplifier will receive adequate ventilation in order to
dissipate the heat it develops during operation. Two popular mounting locations are in the
trunk or under the seat.
Select the location in which you wish to mount the amplifier. Use caution when mounting
amplifier, there are many wires, gas lines, vacuum lines, brake lines as well as a gas tank in
the automobile. Make sure you know where they are when mounting the amplifier to avoid
puncturing lines, shorting wires or drilling holes in the gas tank. Once you are ready, use a
pencil to mark the mounting holes in the bottom panel. After you have marked the locations of
the holes move amplifier out of the way and drill small starter holes to make the tapping
screws easier to install. Use provided screws to tighten down the amplifier.
M
OUNTING LOCATION
BASS
X-OVER
BOOST FILTER LEVEL INPUT
85Hz
CH1
LOW HI
OFF MIN MAX
0dB 12dB 40Hz 130Hz
CH2
BASS
X-OVER
FILTER
LEVEL BOOST
85Hz
CH3
LOW HI
OFF
MIN MAX
40Hz 130Hz 0dB 12dB
CH4
5