VIVOTEK
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default. Upon successful restore, the status LED will blink
green and red during normal operation.
Reset Button
Installation
Hardware Installation
First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your MicroSD/
SDHC Card if necessary.
Tamper-proof Screw
Dome cover
Plastic rear cover
Camera base
8 - User's Manual