Honeywell ADEMCO VISTA-40 Programming Manual page 16

PROMPT
PARTITION
1
ENTER ZONE NO
00 = QUIT 24
L
Example of zone number
suggested by the system.
This indicates that zones
24, 25, 26, and 27 are
available.
24 INPUT S/N L
AXXX-XXXX 1
XMIT TO CONFIRM
PRESS ✱TO SKIP
Entd A022-4063
Rcvd A022-4064
ENTER ZONE NO
00 = QUIT 28
After you have enrolled each wireless device, remove ONE of the serial number labels from that device and affix it in
the appropriate column on the worksheets provided later in this Programming Guide; then enter the other information
(zone number, zone type, etc.) relevant to that device.
5804
Template 1 Loop
1
2
3
4
Template 2 Loop
1
2
3
4
Template 3 Loop
1
2
3
4
EXPLANATION
Enter partition number for wireless key.
Press [✱] to continue.
The system searches for the highest available, consecutive 4-zone group (the four zones required for the
5804 and 5804BD), and displays the lowest zone number of the group.
If you want to start at a different zone number, enter the zone desired and press [✱].
If that zone number is displayed, the system has the required number of consecutive zones available,
beginning with the zone you entered. If not, the system again displays a suggested zone that can be used.
If the required number of consecutive zones is not available at all, the system will display "00."
Press [✱] to accept.
To enter the serial number:
Press and release a button on the wireless key.
OR
Manually enter the 7-digit serial number printed on the device's label.
Press [✱] to accept serial number. The system checks for a duplicate.
If a duplicate exists, a long error beep will sound and the serial number reverts back to all "X"s allowing
you to re-enter the serial number.
Use the [A] key to move forward within the screen, and the [B] key to back up.
If you entered YES previously at the SET TO CONFIRM prompt (see first prompt following entry into the
Expert Programming Mode), the display on the left appears.
To confirm, activate the button on the wireless key that corresponds to this zone.
If the serial number transmitted does not match the serial number entered, a display similar to the one
at the left appears.
If so, activate the loop input or button on the transmitter once again. If a match is not obtained (i.e., summary
display does not appear), press the [#] key and then enter the correct serial number.
Activate the button on the wireless key again after re-entering the serial number.
If the serial number transmitted matches the serial number entered, the system will beep 3 times and
revert to the "Start Zone No." prompt and will show the lowest numbered zone of the next available 4-zone
group (4 consecutive zones) that is available for programming.
After all the wireless keys have been entered, enter 00 for the zone number to quit.
Wireless Key Default Templates
Function Zone Type
No Response
Disarming
Arm AWAY
No Response
Function Zone Type
No Response
Disarming
Arm AWAY
Arm STAY
Function Zone Type
24-Hour Panic
Disarming
Arm AWAY
Arm STAY
5804BD
Template 4
23
22
21
23
Template 5
23
22
21
20
Template 6
07
22
21
20
– 16 –
Loop Function
1 No Response
2 No Response
3 Arm AWAY
4 Disarming
Loop Function
1 No Response
2 Arm STAY
3 Arm AWAY
4 Disarming
Loop Function
1 24-Hour Panic
2 Arm STAY
3 Arm AWAY
4 Disarming
Zone Type
23
23
21
22
Zone Type
23
20
21
22
Zone Type
07
20
21
22