To Install Windows For Workgroups Drivers - HP OmniBook 5700 Installation And Setup Manual

Note
Installing an Operating System
Reinstalling Windows for Workgroups

To install Windows for Workgroups drivers

If you've installed a commercial version of Windows or Windows for Workgroups,
you'll need to manually install the required OmniBook device drivers or use the
OmniBook 5700 Windows 3.X Driver Setup program. These steps modify some of
your system files-such as WIN.INI and AUTOEXEC.BAT. An original version of each
file is preserved in the C:\OMNI_DRV.XXX directory.
1. If you have an internal CD -ROM drive , connect the floppy disk drive to the
OmniBook's parallel port and install the CD-ROM drive in the OmniBook.
–or–
If you have a SCSI CD -ROM drive and a docki ng system , connect the SCSI
CD-ROM drive to the docking system and install the floppy disk drive in the
OmniBook.
–or–
If you have a PC card or parallel port CD -ROM drive , connect the PC card or
Parallel CD-ROM drive and install the floppy disk drive in the OmniBook. See
"To set up a PC card or parallel port CD-ROM drive" on page 1-3-17.
2. Connect the ac adapter to the OmniBook.
3. Insert the Support Utility floppy disk.
4. Reset the OmniBook. The DOS 6.22 Startup menu appears.
5. Click option 5:
Exit to MS -DOS
6. Insert the Recovery CD in the CD-ROM drive.
7. From the DOS prompt, type C:\WINDOWS\WIN to start Windows.
The path may need to be adjusted if Windows was installed in a location other than
the default.
8. From File Manager, go to the CD-ROM drive.
9. Double-click setup.exe in the \omnibook\wfw_drv\disk1 directory.
The OmniBook 5700 Windows 3.x Drivers setup menu appears.
10. Choose Next to install the drivers, then follow the setup instructions.
2-8