To Reset And Restart The Omnibook - HP OmniBook 5700 Installation And Setup Manual

Hint
Starting Out with Your OmniBook
A tour of the OmniBook

To reset and restart the OmniBook

If your OmniBook stops responding—and you can't get around this in Windows—
you can reset the OmniBook and restart Windows.
1. If possible, shut down Windows.
2. Press Ctrl+Alt+Del to reboot the OmniBook.
–or–
Press the square Off button on the left side of the case for 2 seconds, then press
the blue On/Suspend button.
–or–
Insert a straightened paper clip into the small hole below the ac adapter socket
and press the Reset button inside the hole.
Reset button
If you want to reboot from a boot disk in the floppy disk drive, put the disk in the
floppy disk drive before you restart the OmniBook. For example, you can reboot
from the Support Utility disk, then use the commands on this disk to check your hard
disk.
1-16