TC Electronic Studio Konnekt 48 User Manual page 38

STUDIO KONTROL
9 ENCODER and LIGHTRING
The encoder is used to change values for the selected
parameter or function. The encoder and lightring have
various secondary functions when pressed once.
Dim function:
Master, aux 1 , aux 2 and Main mix can have can have an
individual dimmed level setting. Press the encoder to go
to dimmed mode and once more to exit. Dim mode is also
indicated on the lightring. See illustration below.
Not dimmed
P2 P3
MIC PROG
(P1-P3
NEL
The dimmed level cannot be set higher that the
normal level.
10 PANEL
Once you have the TC Near control panel opened, the
PANEL button is a convenient way to maximize the
control panel on top of your DAW application - and
minimize it again. No need to use mouse or keyboard.
11 SPEAKER SET select
• Press and hold:
while pressing:
to select speaker sets.
36
Dimmed
P2 P3
MIC PROG
(P1-P3)
NEL
or or
12 M. MIX - (MON MIX)
The level control for the mixer outputs.
AUX 1 - (SHIFT + M. MIX)
Level control for the AUX 1 channel.
13 EFFECT
Controls the Fabrik R Studio return level on the Main
Mix channel.
AUX 2 - (SHIFT + EFFECT)
Level control for the AUX 2 channel.
14 TALK
When activating the talkback function you most likely
want to attenuate the mix level in the performer's
headphones. The Dim Level function sets this level.
The dim level can never be set higher than the normal
level.
The AUX sends are typically used for setting
individual mix levels on the two headphones outputs.
The AUX 1, AUX 2 and MAIN buttons determine to
which outputs the talkback signal should be sent.
Press the TALK switch on the Studio Kontrol or on the
mixer.
Momentary or latching
Unlike all other functions the Studio Kontrol will not