Using Coaxial Communications - Samsung SCD-3080 Series User Manual

Notes
• Be sure to connect power only after all the installation is complete.
• Note that AC / DC adaptor is not supplied with camera.
• Ground should be connected to the GND terminal.

Using Coaxial Communications

• Coaxial Communications System
• OSD Control method
• Video Cable
The camera's video output port is connected to the monitor with a BNC coaxial
cable, shown below : If the distance between the camera and the monitor exceeds
the recommended maximum, please use an auxiliary video amp.
Notes
• It is recommended that pure copper coax cable is used and not copper coated
steel, as this will cause issues with the communication over the coaxial cable.
CAMERA
SET
UP
DOWN
LEFT
RIGHT
DVR
DVD
Distance
300m
450m
600m
15
COLOR DOME CAMERA
DVR CONTROLLER
MENU/ENTER OSD KEY
UP KEY JOYSTICK UP
DOWN KEY JOYSTICK DOWN
LEFT KEY JOYSTICK LEFT
RIGHT KEY JOYSTICK RIGHT
: BNC
•
• ---- : RS-485
Recommended Cable Specification
3C2V(RG-59/U)
5C2V(RG-6/U)
7C2V(RG-11/U)
SCD-3080