Cpu Installation - Intel 845GV User Manual

Connectors
PS/2 (Bottom)
PS/2 (Top)
USB 0/1
USB 2/3
LPT
VGA
COM1
GAME/MIDI
LINE OUT/LINE IN/MIC
CD_IN
IDE1/IDE2
FDD
PW1
PW2
FAN ½
IrDA
Function Port Pane1
Power Supply LED
HDD LED
ATX Power Supply Switch
Reset Switch
Speaker Input

4.2 CPU Installation

This main board has a socket 478 processor socket. Follow these instructions to install
the CPU:
1. Unhook the CPU socket's locking lever pulling it away from socket and raising it to
the upright position.
2. Match the pin 1 corner of CPU socket to the one of processor, and insert the processor
into the socket. Do not use force.
3. Push the locking lever down and hook it under the latch on the edge of socket.
4. Apply thermal grease to the top of the CPU.
5. Lower the CPU fan/heat sink unit onto the CPU and CPU socket, and then use the
retention module clamps to snap the fan/heat sink into place.
6. Plug the CPU fan power cable into the CPU cooling fan power supply connector on the
main board.
PS/2 Keyboard (Down Purple)
PS/2 Mouse Header (Up Green)
USB 0/1 Connector Port
USB 2/3 Connector Port
Printer Connector Port
VGA Display Connector Port
Serial Ports COM1 Connector Port
Game/MIDI Port
Audio Output/Audio Input/Microphone
CD-ROM Audio Input Port
Primary IDE/Secondary IDE Port
Floppy Disk Drive Connector Port
ATX_20 Power Supply Connector Port
ATX_4 Power Supply Connector Port
CPU System Fan Port
IrDA Infrared Port
Pin 1:Power Supply Anode; Pin 3: Ground
Pin 2: Power Supply Anode; Pin 4: LED Signal
Pin 8: Switch Signal; Pin 10: Power Supply
Anode
Pin 14: Ground; Pin 16:Reset Signal
Pin 9: Speaker Audio Input; Pin 15 : Power
Supply Anode