KitchenAid 4KSMC50S Instructions And Recipes Manual page 9

Assembling Your Tilt-Head Mixer
OFF
To Attach Bowl
1. Be sure speed control is OFF and
mixer is unplugged.
2. Tilt motor head back.
3. Place bowl on bowl clamping plate.
4. Turn bowl gently in clockwise
direction.
5. Plug mixer in proper electrical
outlet.**
To Remove Bowl
1. Be sure speed control is OFF and
mixer is unplugged.
2. Tilt motor head back.
3. Turn bowl in counterclockwise
direction.
WARNING
!
Injury Hazard
Unplug mixer before inserting
or removing beaters.
Unplug mixer before cleaning.
Failure to do so can result in
broken bones or cuts.
To Attach Flat Beater, Wire Whip,
Or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Raise motor head.
3. Slip beater onto beater shaft and
press upward as far as possible.
4. Turn beater to right, hooking
beater over pin on shaft.
5. Plug mixer in proper electrical
outlet.**
To Remove Flat Beater, Wire Whip
or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Press beater
upward as far
ON
as possible
and turn left.
3. Pull beater
from beater shaft.
4. Plug mixer in proper electrical
outlet.**
To Lock Motor Head
1. Make sure motor head is
completely down.
2. Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
To Unlock Motor Head
1. Place lever in UNLOCK position.
NOTE: Motor head should always be
kept in LOCK position when using
mixer.
To Operate Speed Control
Plug mixer in proper electrical
outlet.** Speed control lever should
always be set on lowest speed for
starting, then gradually moved to
desired higher speed to avoid
splashing ingredients out of bowl.
See page 10 for Speed Control Guide.
** See page 3.
7
PIN
Lock Unlock