Safety Instructions; Warnings; Warnings Symbols Used (Depending On Nationality); Places Where Warning Symbols Are Affixed (Depending On Nationality) - Melitta c5 Operating Instructions Manual

2

Safety instructions

2.1

Warnings

2.1.1 Warnings symbols used
(depending on nationality)
The following warnings symbols may be af-
fixed to the equipment.
Low voltage
• Warning of dangerous elec-
trical voltage.
• Electric shocks can lead to
serious injury or death.
• Only authorised technical
personnel may perform
work on electrical installa-
tions.
• The technical safety instruc-
tions must be followed.
• Unplug equipment before
carrying out any work on
electrical installations.
Hot surface / hot internal
components
• Warning of heat which could
lead to injury.
• Allow hot surfaces and com-
ponents to cool before car-
rying out any work on these
component parts.
• If necessary, wear heat-re-
sistant gloves.
OI c5 eng V9 / 18.08.2006
2.1.2 Places where warning
symbols are affixed
(depending on nationality)
NOTE
• The equipment comes sup-
plied with warning symbols
(stickers) affixed wherever
appropriate.
• If any of the warning sym-
bols should fall off during
operation or following clean-
ing work, the operator must
stick these warning symbols
back again immediately.
2.1.3 Safety information in
these Operating
Instructions
In these Operating Instructions, you will
find the following three levels of safety in-
formation:
Level 1
„
WARNING
• A warning refers to signifi-
cant hazards. Failure to fol-
low the relevant safety
instruction could lead to inju-
ry or death.
2 - 1
S
AFETY INSTRUCTIONS
© Cafina / Melitta
E