B-2. Operating Instructions - Motorola HF-SSB Owner's Manual

B-2. Operating Instructions

1. Place the battery charger on a flat surface, protected from sun and
rain.
2. Insert the charger power cable plug into an AC outlet.
3. Connect the battery to be charged to the battery charger: place the
battery socket over the charger pins and press firmly to mate (the
connectors will mate only if battery is placed with the correct
orientation). Beeps must be heard, to indicate proper contact with
the charger.
Note
4. Turn the charger on by setting its front panel POWER switch to
ON:
•
•
5. Start the charging by pressing the red CHARGE pushbutton. The
yellow CHARGE indicator will turn on and the tone stops.
Note
6. The charger now operates automatically.
Note
B-2
Beeps must be heard, to indicate proper contact with
the charger.
If no beeps are heard, remove and then reconnect the
battery. Also check that the charger pins are clean. If no
beeps are heard after the battery is reconnected, the
battery is probably bad and cannot be recharged.
The green UDC indicator will light
The green FINISH CHARGE starts flashing, and a tone is heard.
If the battery is faulty or makes bad contact with the
battery charger, the CHARGE indicator will not turn on
after pressing the CHARGE pushbutton, and no charge
current is supplied to the battery.
If a power source failure occurs while the battery is being
charged, the FINISH CHARGE starts flashing, and an
alarm tone is heard. To resume charging after power
returns, press again the red CHARGE pushbutton.