Rear Panel - Sony SRP-X500P System Integration Manual

SRP-X500P System Integration Guide

3-2. Rear Panel

1 2
!¢ !£
1
ANT IN a/b connectors
(BNC-type)
Connect antennas for the tuner unit
installed in the SRPX-500P. Only the
supplied antennas or the optional UHF
Antenna AN-820A can be used.
2
PROJECTOR CONTROL
CONTROL S IN/OUT connectors
(stereo mini jack)
Used to control the LCD Data Projector
VPL-PX15 exclusively.
3
PROJECTOR CONTROL RS-232C
connector (D-sub, 9-pin, male)
Used to control a projector or display
monitor with an RS-232C connector
that is connected to the 6 OUTPUT
COMPONENT/RGB or OUTPUT VIDEO
connector of the SRP-X500P.
8
3 4 5
!™ !¡
4
REMOTE PARALLEL connector
(D-sub, 25-pin, female)
This connector consists of 10 input pins
and 10 output pins. The SRP-X500P can
be controlled by a switch or volume
controller connected to the input pins.
Connecting these pins to an emergency
broadcast system allows the audio
output of the SRP-X500P to be cut off
during an emergency broadcast.
The following devices can be
connected to this connector:
Input pins
Connectable device
Switch
Volume
Emergency broadcast system
Output pins
Connectable device
LED
Relay
1 6 7
!º
-
With 10 kΩ, B-curve
Connected via relay
24 V DC or less, 40 mA or less
24 V DC or less, 40 mA or less
9 8