Projector Control; Outline; Setting Procedure - Sony SRP-X500P System Integration Manual

SRP-X500P System Integration Guide

5-4. Projector Control

Outline

The SRP-X500P is equipped with PROJECTOR CONTROL
RS-232C and CONTROL S interfaces. By pressing the
AV/RGB SELECT buttons on the front panel, an array of
input signal formats - including composite video,
component video, and computer RGB, which are connected
to the AV/RGB inputs – can be seamlessly switched. In
addition, projector power on/standby control and
projector input selection commands are sent via the
PROJECTOR CONTROL RS-232C or CONTROL S interface.

Setting Procedure

The following flow chart indicates the installation and
settings to control a projector from the SRP-X500P.
Setting the PROJECTOR PROTOCOL selection switch
(refer to SECTION A)
Select PROJECTOR PROTOCOL
from 1 to F when using a Sony
projector or flat panel display.
Refer to the Sony model number
list on the following page.
Cable connection (refer to SECTION B)
Setting the input video signal format and projector
power control (refer to SECTION C)
Completed
20
Set the selector in accordance with the model
number using the projector protocol selector on
the SRP-X500P front panel.
Select "0" if the model number of the projector
or flat panel display is not one of the supplied presets.
Set up the control commands with PROTOCOL SETTING
(refer to SECTION D)
Connect cables for the video signal and
control signal.
Specify the video signal format on AV/RGB inputs.
Set the projector power on/off setting whether or
not it is to be synchronized with the power on/off
status of the SRP-X500P.