To Redial The Last Number - Panasonic KX-TG2336C Operating Instructions Manual

2.4 ghz digital cordless phone
Table of Contents

Advertisement

Making Calls
To dial after confirming the
entered number
Enter a phone number.
1
3334444|
Clear
K
• If you misdial, press Clear. Enter
the correct number.
• If a pause is required when
dialing, press Pause where
needed (p. 51).
• To cancel, press [OFF].
Press [C] or [s].
2
To hang up, press [OFF] or
3
place the handset on the base
unit.
To adjust the receiver/
speaker volume during a
conversation
There are 3 volume levels for the
receiver and 6 volume levels for the
speaker.
To increase volume, press [B].
To decrease volume, press [d].
e.g. Receiver volume: High
Speaker volume: Level 6
Volume
Low
(VE)
K
• The display shows the current volume
setting.
• If you try to increase/decrease
volume when it is at the maximum/
minimum level, the handset will beep
3 times.

To redial the last number

dialed
Press [C] or [s], then press
[REDIAL].
22
Pause
L
High
Mute
L
To redial using the redial
list (Memory Redial)
The last 5 phone numbers dialed are
stored in the redial list.
Press [REDIAL].
1
333-4444
Erase
K
• The last number dialed is
displayed.
Scroll to the desired number by
2
pressing [d] or [B].
• You can also scroll down through
the list by pressing [REDIAL].
• To exit the list, press [OFF].
Press [C] or [s].
3
• To erase an item, scroll to the item
then press Erase.
• If "No items stored" is displayed,
the list is empty.
To put a call on hold
Press [HOLD/INTERCOM]
1
during a conversation.
• "Line on hold." is displayed.
• To transfer the call to the base unit,
see page 40.
Press [HOLD/INTERCOM] again.
2
• "Hold" is displayed.
• You can search the Caller List or
phone book while a call is on hold.
To exit the list, press [OFF]. The
call will remain on hold.
To return to the call, press [C]
or [s].
• The base unit user can also take the
call by pressing [SP-PHONE].
• If another phone is connected on the
same line (p. 8), you can also take the
call by lifting its handset.
• If a call is kept on hold for 6 minutes,
an alarm tone will start to sound and
the Ringer/Message Alert indicator
will start to flash rapidly. After
4 additional minutes on hold, the call
will be disconnected.
dB

Advertisement

Table of Contents
loading

Table of Contents