Table of Contents
Advertisement
B l a c k o u t ( S t a n d b y ) M o d e
In blackout mode, the 2518 DMX Controller blacks out all
devices by sending the DMX value 0 on all channels. Simply
press [Blackout]. Banks and scenes may be selected but not
run. Press [Blackout] again to resume operation.
In standby mode, there is no DMX output from the controller.
Standby mode uses less current and is recommended whenever
the controller is not being used for more than a few minutes to
reduce wear and tear on the electronic components. Press and
hold [Blackout] until the LED lights to activate standby mode.
Press [Blackout] again to return to normal execution.
Disconnect the 2518 DMX Controller from AC power when not in use.
16
2518 DMX Controller
Blackout
(Standby)
Blackout
(Standby)
Scene Bank
Advertisement
Table of Contents
