How To Put Your Ceiling Fan Together - Emerson CF955BS 03 Owner's Manual

How to Put Your Ceiling Fan Together

1. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1). Remove the clevis pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 5.
2. Loosen setscrew in motor coupling if necessary.
Separate, untwist and unkink the black and white
80" motor leads. Route the motor lead wires
through the downrod. Align the clevis pin holes in
the downrod with the holes in the motor coupling.
Install the clevis pin and secure with the hairpin clip
(Figure 2). The clevis pin must go through the
holes in the motor coupling and the holes in the
downrod. Be sure to push the straight leg of the
hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip
snaps around the clevis pin. The hairpin clip must
be properly installed to prevent the clevis pin from
working loose. Pull on the downrod to make sure
the clevis pin is properly installed.
!
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed (as shown in Figure 2) could
result in the fan falling.
AVERTISSEMENT
!
Il est crucial que l'axe d'assemblage dans
l'accouplement du moteur soit installé correctement et
que la vis de blocage soit bien serrée. Si vous ne vous
assurez pas que l'axe et la vis sont installés
correctement (comme cela est illustré à la Figure 2),
le ventilateur risquerait de tomber.
3. While pulling up on the downrod, securely tighten
the setscrew in the motor coupling (Figure 3).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
4. Remove the three screws pre-installed on top of
the fan assembly and retain for use in Step 6.
5. Make sure the grommet is properly installed in the
coupling cover then slide the coupler cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure both
the ceiling cover and the coupler cover are oriented
correctly (Figure 3).
6. Reinstall the three screws, removed in Step 4,
through the coupler cover and into the fan
assembly.
WARNING
HANGER
BALL
SETSCREW
Figure 1
SETSCREW
CLEVIS PIN
Figure 2
CEILING
COVER
COUPLER
COVER
CLEVIS PIN
SETSCREW
MOTOR COUPLING
Figure 3
7
PIN
DOWNROD
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
COUPLER COVER
SCREW (3)
CLEVIS
PIN
HAIRPIN
CLIP
ETL Model No.: CF955-3