Hitachi S-3000W Operating Instructions Manual page 71

Function menu screen
1.1 DTL (Scene 1 to 4) sub-menu (corresponds to scene file)
DTL LEVEL OFF
SOFT
DTL FREQ
SHARP
FLESHTONE OFF
LEVEL
AUTO SETUP
128 0
PHASE
WIDTH 128
2. Function 2 main menu
128
M.BLACK
DYNA CHROMA OFF
DNR MODE MODE1
TYPE 1
ZEBRA
LEVEL LOW
CONTRAST
CS-1 SW
QUICK FOCUS
FULL AUTO
CS-2 SW CONTRAST
QUICK FOCUS
FULL AUTO
MIC SENSE LOW
OFF
PHANTOM
F.AUTO SEL
2-1 Full Auto SEL sub-menu
AES OFF
OFF
FAW
128 0 127
STANDARD
ON
128 0 127
+97 127
0 127
0 127
ON
MODE2
2
MID HIGH
MID HIGH
ON
ON
ON
Sets detail amount.
SOFT: Set to low detail frequency
STANDARD: Set to standard detail frequency
SHARP: Set to high detail frequency
Set to on to moderate flesh tone detail amount. Color setting is
at the DTL sub-menu. (Operates only during remote control.)
Adjusts flesh tone detail amount for a soft image.
Press the button for 1 second to detect the color phase at the
center of the image and set to the optimum position.
Adjusts color phase to flesh tone. The flesh tone detection
range is indicated. (The indication signal is overlapped on the
video output. Use care not to operate this function while ON
AIR.)
Sets the master black value.
Set according to microphone sensitivity. Normally set to MID.
60