Forward-Facing Installation With Latch - Graco Child Restraint Owner's Manual

FORWARD-FACING INSTALLATION WITH LATCH

Adjust child restraint to Upright position
1
(fig. a). Flip recline feet out for
forward facing use.
Make sure Rear Facing
stored. (see fig. b, pg. 37)
2 Place forward-facing
equipped with LATCH
For ease of installation, extend
belt to its maximum length.
Hook connectors to vehicle lower
3
anchors (fig. b). Belt must lay flat and
not be twisted. Pull connectors to be
sure they are securely attached (fig. c).
4
Slide child restraint back until the
restraint is in contact with the vehicle
seat back.
LATCH belt is
on vehicle seat
anchors.
LATCH
Press down firmly in center of child restraint to
5
compress vehicle seat cushion while tightening
LATCH belt by pulling adjustment belt (fig. d).
Pull front to back and left to right at belt path
6
to check for secure installation (fig. e).
7
Check that the lower anchor belt stays tight
and does not slip from the tightened position.
If it does not stay tight, try another seating
position or contact Customer Service.
Attach tether strap hook (A) to anchor
8
hardware (B) and tighten adjustment belt to
remove any slack (fig. f).
Belt must lay flat and not be twisted.
Periodically check that child restraint is
securely installed; adjust if necessary.
To remove LATCH, (see "Removing
Vehicle Anchor Points", p. 36).
LATCH from