Husky POWERWASHER H2000 Installation Manual page 24

PROBLEM OR CONCERN
Gun/Hose - Leaking water
Leaking Oil from Pump
Leaking water from bottom
of unit
Low pressure
Not building maximum Pressure Screen Filter is clogged
Irregular Pressure
No water coming out of Wand Clogged Nozzle
POSSIBLE CAUSE
A small amount of leakage is
normal
Machine Inlet connection is de-
fective
Pump housing is leaking water
Faucet not fully open or unit is not
receiving a full volume of water
Gun or Hose failure
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Water leaking from either Hose
or Unit
Garden Hose length is too long Shorten the length of the Garden Hose. We
Clogged Nozzle
Air in Pump
No Wand attached to the front
of the Gun
Quick Connect is attached
incorrectly
Sceen Filter is clogged
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
SOLUTION
Gun/Hose will need to be replaced. Replacement parts
are not available for the Gun/Hose. Email us at:
customerservice@huskypowerwasher.com
for assistance or order online at:
www.huskypowerwasher.com.
If leakage occurs please contact use directly at
customerservice@huskypowerwasher.com.
Check the Machine Inlet at the front of the unit
to ensure that water is not leaking from it. If the
connection is leaking it will have to be replaced.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Email us at:
customerservice@huskypowerwasher.com
for assistance.
Open the faucet all the way.
Clean the Screen filter as instructed in the section ..
Replace Gun and/or Hose. Contact us at:
customerservice@huskypowerwasher.com
or order online at:
www.huskypowerwasher.com.
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Stop water from leaking before using the unit or
contact us if you need assistance.
recommend a maximum length of  to 0
feet for City water supply and 0 feet for Well
water supply.
Clean the Nozzle as instructed in section ..
Let Pressure washer run with Gun trigger depressed
and Wand removed until a steady stream of water
is released.
Attach either the Click-N-Clean
Wand to the gun. (High Pressure in created with
the Wand and not the Gun).
Clean Nozzle as instructed in section ..
See section .. To Attach Quick Connect properly,
keep the outer collar of the Quick Connect held back
while sliding the Quick Connect all the way forward
against the Inlet Nipple and then release the collar to
lock it into place. (The collar is spring loaded so if it is
released too soon it will not lock into place).
Clean the Sceen filter as instructed in section ..
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.

or Turbo
TM