Pride Mobility Quantum 6000 Owner's Manual page 45

V I I I .
Battery Replacement
A battery wiring diagram is printed on a decal located on the front battery tray. See the specification table for correct
battery specifications.
WARNING! Prevent injury. Do not replace battery when seat is occupied.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that
much weight, be sure to get help. Lifting beyond your capacity can result in personal injury.
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Remove the front cover and foot platform by squeezing the release handles (see figure 33) and lifting the foot platform
bracket up and out.
4. Disconnect the quick release battery connectors. See figure 7.
5. Remove the batteries.
6. Disconnect the battery harness from each battery.
7. Connect the battery harness to the front battery according to the battery wiring diagram. See figure 33.
WARNING! Prevent injury. Make sure you tighten the fasteners so that the connections are secure.
8. Connect the battery harness to the rear battery according to the battery wiring diagram. See figure 33.
9. Install new batteries.
10. Reinstall the front cover and foot platform.
11. Charge the batteries. See VI. "Batteries and Charging."
Quantum 6000
C A R E A N D M A I N T E N A N C E
www.quantumrehab.com 45