Pride Mobility Quantum 6000 Owner's Manual page 27

V . C O M F O R T
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut anticlockwise one-quarter
or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key
and wrench.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew. See
figure 20.
2. Loosen the nut and turn the setscrew anticlockwise to raise
the front of the foot platform and tighten the nut to secure.
3. Loosen the nut and turn the setscrew clockwise to lower
the front of the foot platform and tighten the nut to secure.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear shroud.
3. Unplug the controller connector from the power base.
4. Loosen the mounting screws in the controller mounting
block. See figure 21.
5. Move the controller mounting block and controller to
the other armrest and tighten the mounting screws.
NOTE: For contour seats, remove the wire ties secur-
ing the controller cable to the armrest, loosen the set-
screw on the underside of both armrests, transfer the
controller, and tighten the setscrews. See figures 13
and 22.
6. Route the controller cable to the back of the power
base and plug in the controller. See figures 12 and 13.
7. Replace the rear shround and tighten the fasteners.
8. Secure the controller cable to the armrest with wire ties
(contour seats only). See figure 13.
Quantum 6000
A D J U S T M E N T S
Figure 20. Underside of Foot Platform
SETSCREWS
Figure 21. Controller Position (Synergy Seat)
SETSCREW
Figure 22. Controller Position (Contour Seat)
www.quantumrehab.com
SETSCREW
NUT
MOUNTING BLOCK
MOUNTING SCREWS
27