How To Install And Remove Handles - Amana Distinctions Owner's Manual

How to Remove the Doors and Hinges
5
Detatch main wire connector harness.
(dispensing models only)
Detatch red wire harness
(some models).
How to Replace the Doors

How to Install and Remove Handles

Handles are located within fresh food section of refrigerator. Trim, plugs, and accent pieces will be located within the
literature assembly.
LCD and 5-button Dispenser Models (non-stainless steel)
1
Remove two / " hex nut
1
4
screws from bottom of
refrigerator and freezer
door.
2
Align door handles with top
and bottom sets of door clips,
and slide down until screw
holes on bottom of handles
match with door screw holes.
Distinctions 3-button Dispenser Models
1
Remove four /
1
4
screws from top and
bottom of doors.
2
Align door handles with
screw holes and insert
screws removed in step 1.
How to Remove the Doors and Hinges
" hex nut
Installing Your Refrigerator
continued
6
Remove top hinges along
with doors.
7
Remove bottom hinges with a
/ " hex head driver.
3
8
3
Insert screws removed in step 1
into screw holes at bottom of
handle section.
4
Snap trim over bottom portion
of handles and retainers on
bottom of door
To remove after initial install...
NOTE:
3
Snap colored handle trim over
screw holes at top and bottom of
handles.
To remove after initial install...
IMPORTANT: To avoid damage to handle, use a
flat blade screwdriver edge wrapped in masking
tape to remove colored handle trim.
5