Table of Contents
Advertisement
General Information
READ AND FOLLOW ALL WARNING
Moving, Handling, and Unpacking
AND CAUTION INFORMATION WHEN
Remove and discard all packing materials,
INSTALLING THIS APPLIANCE.
including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the
Remove the burner grates and styrofoam
appliance must be sealed.
off the top cooking surface. Be sure to
remove the burner caps packaged in
• Do not obstruct the flow of combustion and
styrofoam below the burner grates.
ventilation air.
Do not discard the anti-tip metal
bracket supplied with the range.
This is the anti-tip device and must
be installed with the unit. Refer to
"Anti-tip Device Installation"
section.
Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
residues and any dust or debris before being
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.
12
Installation
NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
Door Removal
1
Open door completely. Place pins, supplied with unit, in
pin hole. For personal safety, ONLY use pins
supplied with the unit.
3
Close until pins stop door.
13
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
4
Lift door up and out.
Advertisement
Table of Contents
