Fujitsu fi-4220C Operator's Manual page 90

Symptom 3
Is the shipping lock set at operating
position?
Are the document loaded correctly
on the ADF paper chute?
Is the ADF closed completely?
Is the interface cable connected
correctly?
(when using scanner on SCSI
interface)
Is the SCSI ID set correctly?
Does the Function No. display
indicates any alarm?
Does the alarm state remain
displayed even after the scanner
has been turned off and on
again?
Contact the manufacturer's
authorized service center.
74
The scanning does not start.
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
Set the shipping lock to
correctly position.
Load document correctly on
ADF paper chute.
Remove all documents from
the ADF paper chute. Then
open and close the ADF.
Connect interface cable
correctly.
Set SCSI ID correctly by
SCSI ID switch on rear of
scanner.
The scanner operation is
normal.
The scanner operation is
normal.