Disconnecting The Ipod - Toyota TAS200 Owner's Manual

As soon as the iPod is connected, its power
is automatically turned on.
While the iPod is connected to this unit,
TOYOTA (or (check mark)) is displayed
on the iPod.
— when the ignition switch is set to ACC
or ON, the iPod's battery is charged
while the iPod is connected to this unit
— while the iPod is connected to this
unit, the iPod itself cannot be turned
on or off
— the iPod connected to this unit is
turned off about two minutes after the
ignition switch is set to OFF.
ó Note: To resolve most problems when
using your iPod with the Toyota Audio
system, disconnect your iPod from the
vehicle iPod connection and reset it.
For instructions on how to reset
your iPod, refer to your iPod Owner's
Manual.
ó Note: Push in until you hear a click
to connect firmly. If it does not go in
smoothly, it may be upside down so
do not force it in as this may result in
damage.
Connect the Dock connector directly
to the iPod with Dock connector port.
Do not connect it via the iPod Dock or
other connection.
When the iPod is connected to this
unit, sound will also be heard from the
headphone of the iPod. Use without
the headphone.
If the iPod does not operate with
Toyota Audio system, disconnect the
connector from the iPod and re-
connect again.
To reset the iPod, disconnect the
connector from the iPod, and then
re-connect to the iPod when the
operation screen displays.
26 TAS200

Disconnecting the iPod

remove the USB connector
Example
When disconnecting the iPod connector, grasp the
connector firmly and pull it towards you.
When removing the iPod from this unit,
the iPod main menu appears in the iPod
display after a few seconds.
A