Unlocking Session Types - Alcatel-Lucent OmniSwitch 9000 Series Getting Started Manual

Omniswitch 9000 series
Hide thumbs Also See for OmniSwitch 9000 Series:
Table of Contents

Advertisement

Access to the EMP. By default, only devices in the same
subnet as the EMP will be able to manage the switch
through that port. For information on allowing devices in
other subnets to manage the switch via the EMP, refer to
the OmniSwitch 9000 Series Hardware Users Guide.
5
Save these changes to the switch's running memory by
entering commit system at the boot prompt:
Boot > commit system
This will immediately enable your changes and allow
users to ping the EMP. However, note that these changes
have not yet been saved to the switch's boot.params file
and will be lost if the switch is rebooted.
6
To permanently save these changes to the
boot.params file, enter commit file at the boot prompt:
Boot > commit file
Changes will be preserved following a switch reboot.
7
Return to the CLI prompt by entering exit at the boot
prompt.
Important. Although you have configured the EMP with
valid IP address information, you will not be able to
access the switch through this port for Telnet, FTP,
WebView, or SNMP sessions until you have unlocked
these remote session types. See
Types"
for more information.
22
Your First Login Session
"Unlocking Session

Unlocking Session Types

Security is a key feature on OmniSwitch 9000 switches. As a
result, when you access the switch for the first time, you must
use a direct console port connection. All other session types
(Telnet, FTP, WebView, and SNMP) are "locked out" until
they are manually unlocked by the user.
The CLI command used to unlock session types is
aaa
authentication.
Note. When you unlock session types, you are granting
switch access to non-local sessions (e.g., Telnet). As a
result, users who know the correct user login and pass-
word will have remote access to the switch. For more
information on switch security, refer to the Switch
Management Guide.
Unlocking All Session Types
To unlock all session types, enter the following command
syntax at the CLI prompt:
-> aaa authentication default local
May 2007

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch os9800Omniswitch os9700Omniswitch os9600

Table of Contents