Motorola Symbol LS4278 Product Reference Manual page 36

2 - 2 Symbol LS4278 Product Reference Guide
Standard Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Low/high/low/high beeps
Low/high/low beeps
High/high/high/low beeps
Parameter Menu Scanning
Long low/long high beeps
High/low beeps
High/low/high/low beeps
Long low/long high/long low/long high beeps
Wireless Operation
High/low/high/low beeps
Low/high beeps
High/low beeps
Long low/long high beeps
Long low/long high/long low/long high beeps
Code 39 Buffering
High/low beeps
Three long high beeps
Low/high/low beeps
Low/high beeps
Host Specific
USB only
Four high beeps
Scanner gives a power-up beep after
scanning a USB Device Type.
Out of memory - unable to store a new bar code.
ADF transmit error.
RS-232 receive error.
Input error, incorrect bar code or Cancel scanned, wrong entry,
incorrect bar code programming sequence; remain in program
mode.
Keyboard parameter selected. Enter value using bar code keypad.
Successful program exit with change in the parameter setting.
Out of host parameter storage space. Scan
page 5-3.
Pairing bar code scanned.
Bluetooth connection established.
Bluetooth disconnection event.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after a bar code is
scanned, check the host device for receipt of transmitted data. It is
possible that an attempt was made to transmit the last bar code
scanned after the connection was lost.
Page timeout; remote device is out of range/not powered.
Connection attempt was rejected by remote device.
New Code 39 data was entered into the buffer.
Code 39 buffer is full.
The Code 39 buffer was erased or there was an attempt to clear or
transmit an empty buffer.
A successful transmission of buffered data.
Scanner has not completed initialization. Wait several seconds and
scan again.
Communication with the bus must be established before the
scanner can operate at the highest power level.
Indication
Default Parameters on