Connecting A Keyboard Wedge Interface - Motorola Symbol LS4278 Product Reference Manual

6 - 2 Symbol LS4278 Product Reference Guide

Connecting a Keyboard Wedge Interface

NOTE See
communication.
The scanner must be connected to the cradle for the host parameter setting to take effect. When the scanner is not
connected to a cradle, and a host parameter bar code is scanned, a long low/long high beep sequence sounds.
Keyboard Connector
Keyboard Wedge Connection with Y-cable
Figure 6-1
To connect the Keyboard Wedge interface Y-cable:
Turn off the host and unplug the keyboard connector.
1.
Attach the modular connector of the Y-cable to the host port on the bottom of the scanner cradle. See
2.
Connecting the Cradle on page
Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.
3.
Connect the round female DIN keyboard connector of the Y-cable to the keyboard connector.
4.
If needed, attach the optional power supply to the connector in the middle of the Y-cable.
5.
Ensure that all connections are secure.
6.
Turn on the host system.
7.
Select the Keyboard Wedge host type by scanning the appropriate bar code from
8.
Parameters on page
To modify any other parameter options, scan the appropriate bar codes in this chapter.
9.
Chapter 4, Radio Communications
Male DIN
Connector
Female DIN Keyboard
Connector
1-6.
6-4.
for information about scanner/cradle pairing and wireless
Y-cable
Keyboard Wedge Host