Do you have a question about the GEN1 and is the answer not in the manual?
Questions and answers
Mark Sutich
May 18, 2025
How do I know if the NOCO Genius 1 charger is ready to use. Do I need to charge the charging unit
1 comments:
Mr. Anderson
May 23, 2025
To tell if the NOCO Genius 1 charger is ready to use, follow these steps:
1. Check the fuse in the battery connector harness. If the fuse is blown, replace it with a 15A Automotive Blade Fuse. 2. Before plugging in the charger, measure the battery voltage with a digital voltmeter and record the value. 3. Plug the charger into an electrical outlet. 4. Wait at least 30 seconds. 5. Measure the battery voltage again. If the charger is working, the voltage should be higher than the initial reading and slowly increasing.
If these conditions are met, the charger is ready to use.
Need help?
Do you have a question about the GEN1 and is the answer not in the manual?
Questions and answers
How do I know if the NOCO Genius 1 charger is ready to use. Do I need to charge the charging unit
To tell if the NOCO Genius 1 charger is ready to use, follow these steps:
1. Check the fuse in the battery connector harness. If the fuse is blown, replace it with a 15A Automotive Blade Fuse.
2. Before plugging in the charger, measure the battery voltage with a digital voltmeter and record the value.
3. Plug the charger into an electrical outlet.
4. Wait at least 30 seconds.
5. Measure the battery voltage again. If the charger is working, the voltage should be higher than the initial reading and slowly increasing.
If these conditions are met, the charger is ready to use.
This answer is automatically generated