MSI G52-72801X2 User Manual page 37

1. Install the CrossFire Edition graphics card in the Master PCIEX16 (PCI_EX1) slot.
Unplug the PCI-E X16/X8 Switch Card and installing the CrossFire Ready graphics
card in the Slave PCIEX16 (PCI_EX2) slot.
2.Use the external cable to connect the two graphics cards. The cable is attached
from the CrossFire Ready graphics card's DVI connector to the CrossFire Edition high
density input connector (DMS). Then connectting a monitor to the left DVI connector.
The CrossFire Edition
graphics card.
DMS connector
Important
1. Mainboard photos shown in this section are for demonstration only. The
appearance of your mainboard may vary depending on the model you purchase.
2. Only Windows® XP with Service Pack 2 (SP2)& Windows® XP Profes
-sional x64 Edition support the CrossFire function.
3. Always install the CrossFire Edition graphics card in the master PCIEX16
slot, and install the CrossFire Ready graphics card in the Slave PCIEX16
slot to make the CrossFire technology functions properly.
DVI connector (connectting
to the monitor)
Hardware Setup
T he Cros sFire Ready
graphics card.
DVI connector
2-21