Related Manuals for Fusion MS-NRX200
Summary of Contents for Fusion MS-NRX200
- Page 1 MARINE WIRED REMOTE MS-NRX200 Specifications and design are subject to change without notice...
-
Page 2: User Interface And Controls
PLAY/PAUSE CURRENT TRACK At FUSION, we believe that products should be designed to perform season after season even after exposure to some of the harshest marine conditions. With this longevity in mind, all True Marine products are designed and engineered from the ground up - specifically for use on the water. -
Page 3: Installation
127250: Vessel Heading (Magnetic Heading, Correction, Deviation) 128259: Speed Water referenced (Speed Water, Speed Ground) The MS-NRX200 is a plug and play device with two connection options. Connect the remote control to 128267: Water Depth (Depth at transducer, transducer offset) - Page 4 INSTALLATION OVER A NMEA2000 NETWORK. POWER ON/OFF – NMEA2000 REPEATER MODE As previously mentioned, the FUSION MS-NRX200 can be connected to a NMEA2000 network in two ways as described below. If the remote control has been configured to display NMEA2000 data sentences it can be turned on independently of the FUSION Marine Stereo.
-
Page 5: Selecting Units Of Measure
(b) New NMEA2000 Network The NRX200 remote control can be configured to display NMEA2000 network data, the following Fusion provides a NMEA2000 Starter Kit MS-N2KSTART for creating a new NMEA2000 network on options are available: your vessel. • Wind Direction MS-N2KSTART - NMEA2000 Starter Pack •... -
Page 6: Operation
Press the ‘Menu’ button and select ‘SETTINGS’ > ‘STEREO’. Select the desired stereo from the list of available devices on the network. Press the ‘Menu’ button to exit. VOLUME ADJUST Turn the ‘Rotary Encoder’ to adjust volume levels. Refer to the FUSION Marine Stereo user manual for DRILL 4xPILOT HOLES 2.5mm (3/32") details on how to select zones.
Need help?
Do you have a question about the MS-NRX200 and is the answer not in the manual?
Questions and answers