Locate the side handrails. Remove and place aside the four screws (two per side) that are on the
stub sticking out of the upper end of the side handrails. Slide the side handrails stub into the front
handrail, replace the four screws (two per side), and tighten loosely. Note:
up, loosen the lower pair ofscrews and rotate the stub in the side handrail until they do line up.
Attach the side rails to the side of the frame, inserting two bolts (3/8-16
side, through the side handrails and the frame. Connect the bolts to two nuts (3/8-16, Nylok Hex)
one per side. Tighten all bolts and screws.
CABLE
HANDRAIL
INSERT
RUBBER GASKET
5
BOLT
If
the holes do not line
4.0", SHCS), one per
x